throttle cable

All former posts from our original WWWBoard forum are here

Moderators: smurph, rztom

Locked
Message
Author
ALAN

throttle cable

#1 Post by ALAN » Wed Jun 22, 2005 12:21 pm

OK lads just fitted new throttle cable pull and return problem is where do you start adjustments . Both adjust at twist grip ,both adjust at carbs and pull side adjusts at oil pump.Presuming nothing altered carb side should just need fitting and setting to open and close simultaniously . once fitted in twist grip slack taken up ok ?.Came to check oil pump conn way out and wont come in on adjuster. In manual says adjust so mark on hole lines up with mark on pump .There are two marks shown in picture in manual and mine is only picking up WRONG ONE.If I try to adjust at twist grip cables go tight and slow to return .Long winded I know but is there a set system to do it idiot proof
<br>
<br><hr size=3 width=75%><p>


alantp@tiscali.co.uk

Locked