Zeeltronic wiring query?
Moderator: rztom
-
- Posts: 93
- Joined: Sat Apr 16, 2011 6:02 pm
- Location: Devon UK
Zeeltronic wiring query?
Hi
I have now fitted the zeel cdi/pv controller, i have one query with the Gray wire, should i connect it to the Orange/Black wire?
my bike is standard rd500 UK spec does not have a TPS!
The wiring diagram says "if TPS not used then connectO/B andGr. Program only 100% ignition curve" Can anyone explain this to me please??
cheers colin
I have now fitted the zeel cdi/pv controller, i have one query with the Gray wire, should i connect it to the Orange/Black wire?
my bike is standard rd500 UK spec does not have a TPS!
The wiring diagram says "if TPS not used then connectO/B andGr. Program only 100% ignition curve" Can anyone explain this to me please??
cheers colin
Basically when you don't have a TPS, you join those wires together. It tells the zeeltronic that you have 100% throttle all the time.
So when you join the wires, you only configure the 100% curve values in the zeeltronic, because the other values are not used.
From memory, when you use a TPS with Zeeltronic there are 3 curves that you can configure for different throttle openings.
So when you join the wires, you only configure the 100% curve values in the zeeltronic, because the other values are not used.
From memory, when you use a TPS with Zeeltronic there are 3 curves that you can configure for different throttle openings.
-
- Posts: 93
- Joined: Sat Apr 16, 2011 6:02 pm
- Location: Devon UK
Re: Zeeltronic wiring query?
What is TPS?
Re: Zeeltronic wiring query?
Throttle Positioning Sensor................. I think?
Re: Zeeltronic wiring query?
Hi.
I'm pretty much doing the same at the mo.
As I'm thick.....and also "Dont" have a TPS.....can anyone just confirm......
"The Orange/Black from the Zeeltronic CONNECTS directly to the Grey"......and does not connect to the servo at all?
It "DOESN'T" connect to the "Yellow/Blue" at the servo and then run a feed to the grey??.
Correct??
I'm pretty much doing the same at the mo.
As I'm thick.....and also "Dont" have a TPS.....can anyone just confirm......
"The Orange/Black from the Zeeltronic CONNECTS directly to the Grey"......and does not connect to the servo at all?
It "DOESN'T" connect to the "Yellow/Blue" at the servo and then run a feed to the grey??.
Correct??
I'd rather be scared to death than bored to death!
Re: Zeeltronic wiring query?
If no TPS, then O/B gets connected to Gr & Y/Bl on servo.
I.e. The Y/Bl on servo always gets connected to the O/B on the Zeel, but if no TPS, then just connect the Gr to those colours as well.
Remember to program 100% in the set-up.
Rgds.
I.e. The Y/Bl on servo always gets connected to the O/B on the Zeel, but if no TPS, then just connect the Gr to those colours as well.
Remember to program 100% in the set-up.
Rgds.