Athena Cylinder Water Bung

General forum on engines, transmissions, gearing and modifications to each

Moderator: rztom

Post Reply
Message
Author
Headcoats
Posts: 848
Joined: Sun Apr 04, 2010 6:13 am
Location: Pig On The wall Country

Athena Cylinder Water Bung

#1 Post by Headcoats » Sun Sep 16, 2018 3:29 pm

Just trying to figure out how the hell they fit in cylinders as Athena never machined the area to get it in flush, just left the rough castings :smt021

Also as pointed out, even when seated properly, the actual bung hangs halfway out in the RZ YPVS cases as that gasket area is smaller on our bikes

What is a tried and tested solution to this :smt017

Image

Here's the hole !
Cryin' In The Beer Of A Drunk Man

Post Reply