Page 1 of 1

Clutch stocked/hanging Help

Posted: Thu Feb 08, 2018 6:19 pm
by Mcqeen
Hi forum :smt041

Messing with left clip-on, removed the clutchlever and wire...

Remounting wire and lever... and the clucth is hanging and there is no tension on the wire!!!... :smt010

What/how can i get the clutch released again?? :smt017

Regards Stig

Re: Clutch stocked/hanging Help

Posted: Thu Feb 08, 2018 8:35 pm
by hondaror
Hi Stig, check the cable (wire) at the clutch arm end. (Under the carbs). It will often come off there when you remove the lever.

Re: Clutch stocked/hanging Help

Posted: Thu Feb 08, 2018 9:39 pm
by Mcqeen
The cable and lever is fine...

It is like the clutch has been "over pulled" when i was dismounting the cable and the clutch has locked and wont release itself again...

The clucth arm didn´t return after tension.

Hope it makes sense... Engwish not first lagunes :smt002

Re: Clutch stocked/hanging Help

Posted: Fri Feb 09, 2018 1:29 am
by hondaror
I'd drop the oil and pull the case. You might have broken plates.

Re: Clutch stocked/hanging Help

Posted: Sun Feb 11, 2018 10:44 pm
by Mcqeen
Hmm... Ok, i will report back what happend

Re: Clutch stocked/hanging Help

Posted: Sat Sep 08, 2018 8:14 am
by Mcqeen
Completly forgot about returning with the clutch issue and solution :smt015

When removing the clip on´s, i heard a little noise... like when your dropping a 5mm nut to the floor, you didn´t see were it landed and start to wonder if you heard rigth, because the sound has nothing to do with the work your doing... Yes?? :smt048

I grabbed my Haynes manual, read about the clucth adjustment, dismantling and removing the clutch, got my tool and on with it... :smt038

I ended up with doing it five times :smt042

Step by step, before deciding that there is nothing wrong with the clutch... i have done it rigth according to the book :smt017

Thinking very hard about it :smt017 I remembered the litle noise i had heard and whent backwards to where it all startet and looking at the lever and cableadjuster...cable beeing ca. 1cm to long.... :smt018

Was that the sound???... and extra customized cable adjuster, that i made years ago do to the long cable...FUUUUUUUUUCK ME!!!! :smt021 :smt021

No further questions your Honor :smt086

The clutch is now in a god working order :smt002 :smt023

Re: Clutch stocked/hanging Help

Posted: Sat Sep 08, 2018 5:25 pm
by silverstrom
Lol...funny how memory fails us as times.

Re: Clutch stocked/hanging Help

Posted: Sun Sep 09, 2018 1:10 pm
by hondaror
Glad you got it all worked out.