RZ/RD 350 & Misc. 2-Stroke Tech BBS

Technical Forums for Two-Stroke Nuts
It is currently Sun Nov 19, 2017 6:55 pm

All times are UTC - 4 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Nov 12, 2017 12:18 pm 
Offline

Joined: Mon Jul 03, 2017 7:01 am
Posts: 23
Hi
After frying my stator (as described here viewtopic.php?f=3&t=15095)
I have started playing With the idea of rewinding the stator myself. After a quick search both here and on Google I think it should be within reach.

Anyway, I found that the charging part of the stator has a somewhat non-symmetrical layout that had me puzzled. That is - it has 14 charging coils where I was expecting to find a factor of 3 number of coils. However the spacing was phase 1,2,3...1,2,3 and so on untill it ended with 1,2 making up a total of 14 coils. I discovered that the number of windings was approximately 40 for each coil and in 3 cases it was only 20 windings/turns on the coi. When I added them all up, I found that phase 1 and 3 had 160 turn totalt distributed through its coils, but phase 2 had 180!?

My initial thoughts was that the total number of windings should have been equal between all three phases, even if the layout is a non-symmetrical distribution.

I am therefore asking you all if I shuold leave it like this - or should I compensate when rewinding and loose 20 turns on phase 2 to make them all 160? Or is there some though behind these from the factory perhaps? Its beyound me for sure at this point, and I have no idea if it has been rewound before.
If anyone has any data to support the number of windings etc I would be pleased to hear it.

Check out my stator disassembly notes inn pptx format here https://1drv.ms/p/s!ArCvt5JQQSh2sxLCkCriNj4_-9SQ

Thanks for reading
Kjell


Last edited by kjellz on Sat Nov 18, 2017 6:57 pm, edited 1 time in total.

Top
 Profile  
Reply with quote  
PostPosted: Sun Nov 12, 2017 3:26 pm 
Offline

Joined: Tue Jul 23, 2013 2:16 pm
Posts: 89
RM stator rewinds coils and are very good about technical questions like what you are asking. You might want to give them a call.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 4 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group