If someone wants to fabricate the brackets that are riveted inside the fairing cowl and also that lower bar piece that connects the headlight/gaugecluster monstrous bracket I'll gladly pay.
Go team?
Looking for some reference pictures of the RZ cowl removed
Moderator: rztom
Re: Looking for some reference pictures of the RZ cowl removed
Jeez folks I thought we were a team
Re: Looking for some reference pictures of the RZ cowl removed
the piece that acts like a hinge at the bottom of the cowl is similar to one half of a cabinet hinge. You may be able to modify a hinge from a hardware store and match a clevis pin to fit.
Just a thought....
Just a thought....
Re: Looking for some reference pictures of the RZ cowl removed
Can anyone supply exact measurements for these points? Thanks to whoever posted these photos.
- Attachments
-
- HELP-2a.jpg (231.31 KiB) Viewed 730 times
Re: Looking for some reference pictures of the RZ cowl removed
It's very close to 11.25 inches
Ken's Garage
https://www.youtube.com/c/KensGarage1
https://www.youtube.com/c/KensGarage1
Re: Looking for some reference pictures of the RZ cowl removed
That's super helpful. Thank you.
Is that 11.25 hole center to hole center? I can't really tell where your measurement starts.
Is that 11.25 hole center to hole center? I can't really tell where your measurement starts.
Re: Looking for some reference pictures of the RZ cowl removed
Yes center to center
Ken's Garage
https://www.youtube.com/c/KensGarage1
https://www.youtube.com/c/KensGarage1